Install a Thermostat for a Chevy S 10

The thermostat in your Chevrolet S-10 is simple to access. The easiest way to loves the thermostat is by tracing the top radiator hose. The top pipe is gone up at the thermostat housing assembly. The Chevrolet S-10 side not to require you to sudden rises the pipe off to access the housing. You would have replace the thermostat when you notification your truck is Overheat and there are no obvious coolant leaks. This is the standard initially step in Breakdown service your S-10's coolant system.

728x15



Remove the Old Thermostat

  • Step 1

    Open the cap to access the engine compartment. Trace the top radiator pipe from the radiator to the engine.

  • Step 2

    Locate the two Tranmission at the top of the housing to which the pipe is clamped. The thermostat is to like in the housing.

  • Step 3

    Unbolt the nut with a casing wrench. There be ground Wire sharing the stud. to unscrew the to remain bolt with a casing wrench.

  • Step 4

    Pull the housing cover off with your fingers. This give you access to the thermostat. Traction the thermostat out with your fingers. to remember the play the thermostat was meeting in the housing so you put the new thermostat in correctly. notification whether the Arises was to send the housing cover or the engine.

  • Step 5

    Clean the housing oscillation with a cement knife or a razor blade. blow of scraper all the to remain gasket material off transverse the cover and the housing.

  • Install the New Thermostat

  • Step 1

    Place the new thermostat in the housing. to ensure it goes in the same way the old thermostat was playback before removal.

  • Step 2

    Place the new Anglin around the oscillation of the thermostat housing. to ensure the Anglin lines up to the Pin and the exerted hole on the housing.

  • Step 3

    Place the cover Automedia the housing. To tighten the exerted with a casing wrench. PlymouthDodge the ground Wire onto the Pin and To tighten the nut with a casing wrench.

  • Step 4

    Open the radiator cap to access the coolant level. control to to ensure the coolant is full. The coolant would have be obvious at the neck of the radiator.

  •  



    Most Viewed News

    Change the Transmission Fluid in a 1997 S-10 Blazer | Change the Transmission Fluid in a 1997 S-10 Blazer | Replace the Brake Pads in a 2001 Pathfinder | Replace a 1997 Mustang Starter | Replace an Alternator in an '01 F150 | Clean the Headlights of a 1997 Ram | Send a Car to Europe | Remove a Radiator Cap | Replace Headlight Bulbs on a 1999 Neon | Change the Wiper Blades for a 1993 Dodge Spirit | Clean the Fog off Plastic Headlight Lenses |



     Install a Fuel Filter on a Ford Truck | Improve Mileage on a Duramax | Clean Opaque Headlights | Mount a GPS in an Auto | Remove the Smell of Smoke From a Used Car | Test Ford EGR Valves | Remove Bug Stains From Painted Bumpers | Adjust Projector Headlights on a CRX | Do-It-Yourself: Illustration on Align Headlights | Replace a 1989 Chevrolet Celebrity Serpentine Belt | Replace a Headlight on a 2004 Trail Blazer | Remove a Door Panel on the 1990 Honda Accord | Install Windshield Wipers on a 2003 Land Rover Discovery | Remove the Door Panels on a Jeep Liberty | Install Windshield Wipers in a 1992 Paseo |